F16 Deskpit Table Mount – Mounting Tutorial

Assembling tutorial for the Simgears F16 Deskpit – Table Mount Version. The Deskpit is made of 4 main blocks and we show you how to assemble them.

TRANSCRIPTION:

Good evening, guys!
Thank you to follow us and I’ll show you what you are going to receive when you have a Deskpit.
Inside the box you will receive 4 main pieces that’s: the HUD block, left and side part and center pedestral part.
This is a reduction of the real one, of course, so you can keep everything in a very tiny space.
Above this, you will receive also a box. Inside the box you will find the screws: N6: 8 pieces and 4 pieces of N4. These are hand screws that you can easily install. This is a set of 4 screws for the ICP These are another 4 screws to setup everything and tide all together and this is a small set of screws that you can use in case you purchase the MFD from another company like Thrustmaster or Cubesim.

So, now we are going to show you how to assemble all together.
Ok, so now this is how we suggest to install the Deskpit on a table for the table mount version, of course, and you start to tight the screws on the table just not so strong: strong enough to lock it but not so much. ok?
Then, after this, you take the center pedestral and 2 N6 screws and you’re gonna chase the mark on it and lock them together.
It is quite easy, I mean, it doesn’t gonna take more than 5 minutes to fix everything.
Once you have done this, next step is to take this block, put the block under, below, just ensure that everything is on the right position, always following the line and tide up the N6 hand screws.
Both, are 2 on top part and 2 on lower part on each side.
So, once you are here, you are at the middle of the trip. Next step is to lock the last pieces.
Always the same steps.
Very strong.
Next step is to add HUD block.
Ok, so we’ve got the last 4 screws, that are conic ones, that we’re going to ensure a little bit more the top part and make all the structure a little bit more narrow and tight.

Ok, so now we’ve got everything installed properly and as I told you before, we can host on this the RWR… R. W. R.
There is also the chance to host the DED and also the ICP. The ICP here is a PRO version so you can just put the cable into the right place and then using the 4 screws up here, that you find in the box, you can tight all together.

The last thing that we’d like to show you that we are going to use for the center pedestral and after that, when we will produce the monitors, we are going to use plexiglass: this is a special plexiglass, it’s a no-reflex one. It’s not a standard no-reflex: it’s a good quality no-reflex material.

So, here you can see the table mount version of the deskpit installed and for any question you can e-mail us: we’ll try to give you all the informations that you want. Thank you, bye bye!